NOTE Check the speed sensor signal last See Precheck

OK: Go to next step.

3. Check for open and short circuit in harness and connector between each speed sensor and skid control ECU (See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE ).

NG: Repair or replace harness or connector.

OK: Go to next step.

4. Check sensor installation.

CHECK:

2004 BRAKES ABS With EBD & BA & TRAC & VSC System - Diagnostics - Sequoia

Check the speed sensor installation. OK:

The installation bolt is tightened properly and there is no clearance between the sensor and the front steering knuckle or the rear axle carrier. Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

Self Centering Bolts

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment