NOTE When replacing the master cylinder pressure sensor perform the zero point calibration See Precheck

NG: Go to next step. 5. Check yaw rate and deceleration sensor.

2004 BRAKES ABS With EBD & BA & TRAC & VSC System - Diagnostics - Sequoia

PREPARATION:

Disconnect the connector from the yaw rate and deceleration sensor. CHECK:

a. Turn the ignition switch ON.

b. Measure voltage between terminal VYS and GYAW of skid control ECU.

Rate Sensor Toyota Rav4

Fig. 86: Identifying Yaw Rate & Deceleration Sensor Connector Terminals VYS & GYAW

For Measuring Voltage Between Them

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Fig. 86: Identifying Yaw Rate & Deceleration Sensor Connector Terminals VYS & GYAW

For Measuring Voltage Between Them

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

OK: Replace yaw rate sensor assembly.

NOTE:

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • DIRK FURST
    Where is master cylinder pressure sensor toyota?
    5 years ago
  • espedito
    How to replace a toyota corolla 2004 yaw sensor?
    5 years ago
  • ZACHARY
    How to replace the master cylinder on my 2004 seqoiua?
    2 years ago
  • nazario
    How to replace of deceleration sensor in 2004 sequoia?
    1 year ago

Post a comment