Toyota Sequoia Driveline Grinding

G02927698

Fig. 4: Checking Bearing Backlash & Axle Shaft Deviation Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

6. REMOVE AXLE SHAFT ASSEMBLY

a. Remove the 4 nuts.

b. Pull out the axle shaft assembly.

NOTE: Be careful not to damage the oil seal.

c. Remove the O-ring from the axle housing.

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

Removing Rear Rotor Toyota Sequoia

G02927699

Fig. 5: Removing Axle Shaft Assembly Nuts Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

DISASSEMBLY

1. REMOVE BEARING RETAINER (DIFFERENTIAL SIDE) AND SPEED SENSOR ROTOR

a. Attach 4 nuts to the serration bolts and remove the serration bolts from the backing plate using a hammer.

NOTE: Do not reuse the nuts previously removed from the vehicle.

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

G02927700

Fig. 6: Removing Serration Bolts From Backing Place Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Grind the retainer and sensor rotor surfaces using a grinder, then pry them out with a chisel and hammer.

2. REMOVE SNAP RING FROM AXLE SHAFT

Using a snap ring expander, remove the snap ring.

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

Toyota Tacoma Rear Axle Diagram

G02927701

Fig. 7: Grinding And Prying Out Retainer & Sensor Rotor Surfaces Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

3. REMOVE REAR AXLE SHAFT FROM BACKING PLATE AND BEARING ASSEMBLY

a. Attach washers and nut to the serration bolts, then torque the nuts to install the serration bolts to the backing plate.

b. Remove the 4 nuts from the serration bolts.

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

Fig. 8: Installing Serration Bolts

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Fig. 8: Installing Serration Bolts

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

c. Position SST on the backing plate with 4 nuts.

SST 09521-25011, 09521-25021

d. Using a press, remove the rear axle shaft, spring washer and bearing retainer from the backing plate.

e. Remove the SST.

SST 09521-25011, 09521-25021

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

09521 25021

G02927703

Fig. 9: Removing Rear Axle Shaft Spring Washer & Bearing Retainer From Backing Plate Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

4. REMOVE OIL DEFLECTOR AND GASKET

Using a brass bar and hammer, remove the 6 hub bolts, oil deflector and gasket.

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

Sst 09521 25011

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment