P

G02927704

Fig. 10: Removing Oil Deflector & Gasket Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

5. REMOVE BEARING ASSEMBLY

Attach 4 nuts to the serration bolts and remove the serration bolts from the backing plate using a hammer.

NOTE: Do not reuse the nuts previously removed from the vehicle.

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

G02927705

Fig. 11: Removing Serration Bolts From Backing Plate Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

INSPECTION

INSPECT AXLE SHAFT

Using a dial indicator, measure the runout of the shaft and flange.

Maximum shaft runout: 2.0 mm (0.079 in.) Maximum flange runout: 0.1 mm (0.0040 in.)

If the rear axle shaft or flange are damaged or worn, or if runout is greater than the maximum, replace the rear axle shaft.

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

G02927706

Fig. 12: Measuring Runout Of Shaft & Flange Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

REPLACEMENT

REPLACE OIL SEAL (INNER SIDE)

a. Using SST, remove the oil seal. SST 09308-00010

2004 DRIVELINE/AXLES Rear Axle Shaft - Sequoia

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment