Removal Installation

FRONT WHEEL BEARING

Remove hub and knuckle. See removal under HUB & KNUCKLE . Diassembly

1. Mount the axle hub in a soft jaw vise. On 2WD models, using a screwdriver, remove the grease cap. On 4WD models, using a screwdriver, remove the oil seal (inside). See Fig. 1 and Fig. 2 .

2. On 2WD models, remove lock nut and remove the ABS speed sensor rotor/spacer. Using a chisel and hammer, loosen the staked part of the lock nut. Using Special Tool (09318-12010), remove the lock nut. Remove the ABS speed sensor rotor/spacer. See Fig. 2 .

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment