Seal packing Part No or equivalent

• Install a nozzle that has been cut to a 2 - 3 mm (0.08 - 0.12 in.) opening.

2004 ENGINE Water Pump - Sequoia

• Parts must be assembled within 3 minutes of application. Otherwise the material must be removed and reapplied.

• Immediately remove nozzle from the tube and reinstall cap.

c. Install a new O-ring to the water inlet housing.

d. Apply soapy water on the O-ring.

e. Attach the water inlet housing end to the front water bypass joint hole.

Toyota Inlet Housing 16321 1011
Fig. 11: Applying Seal Packing To Sealing Groove Of Water Inlet Housing Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

f. Install the water inlet and housing assembly with the 2 bolts. Alternately tighten the bolts.

NOTE: Each bolt length is indicated in the illustration.

Bolt length:

2004 ENGINE Water Pump - Sequoia

22 mm (0.87 in.) for B g. Connect the water bypass hose to the water inlet housing.

Toyota Tercel Water Pump Schematics

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Responses

  • Khadija
    How to replace water pump on 04 toyota sequoia illustration?
    8 years ago
  • Mandy
    How to change water pump in 2002 sequoia?
    7 years ago

Post a comment