Go to step C Go to step D Go to step

2006 RESTRAINTS Supplemental Restraint System - Sequoia

2. CHECK CONNECTOR

a. Check that the floor wire connector (on the front seat outer belt RH side) is not damaged.

OK: The lock button is not disengaged, or the claw of the lock is not deformed or damaged. NG: REPAIR OR REPLACE FLOOR WIRE OK: GO TO NEXT STEP.

3. CHECK FLOOR WIRE (FOR SHORT)

a. Release the activation prevention mechanism built into connector "B" (See CHECK MODE PROCEDURE ).

b. Measure the resistance according to the value(s) in the table below. OK

TESTER CONNECTION SPECIFI

ED CONDITION CHART

Tester Connection

Condition

Specified Condition

P11-1 (PR+) - P11-2 (PR-)

Always

1 Mohms or higher

OK: Go to step 10

2006 RESTRAINTS Supplemental Restraint System - Sequoia

Fig. 294: Checking Floor Wire (For Short) Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2006 RESTRAINTS Supplemental Restraint System - Sequoia

4. CHECK FLOOR WIRE (FOR OPEN)

a. Measure the resistance according to the value(s) in the table below.

TESTER CONNECTION SPECIFI

ED CONDITION CHART

Tester Connection

Condition

Specified Condition

P11-1 (PR+) - P11-2 (PR-)

Always

Below 1 ohms

OK: Go to step 11

2006 RESTRAINTS Supplemental Restraint System - Sequoia

Fig. 295: Checking Floor Wire (For Open) Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2006 RESTRAINTS Supplemental Restraint System - Sequoia

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment