Caution Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment

a. Turn the ignition switch LOCK position.

b. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

c. Disconnect the connectors from the center airbag sensor assembly.

d. Disconnect the connectors from the steering wheel pad.

e. Disconnect the connectors from the front passenger airbag assembly.

f. with Side and curtain shield airbag:

Disconnect the connectors from the side airbag assembly LH and RH.

g. with Side and curtain shield airbag:

Disconnect the connectors from the curtain shield airbag assembly LH and RH.

h. Disconnect the connectors from the front seat outer belt LH and RH.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment