Check Mode Procedure

Total OBD & ECU Auto Diagnostics

TOAD Auto Software

Get Instant Access

a. Make sure that the following conditions below are met:

1. Battery positive voltage 11 V or more

2. Throttle valve fully closed

3. Transmission in the P or N position

b. Turn the ignition switch OFF.

c. Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.

d. Turn the ignition switch ON.

e. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / CHECK MODE.

f. Change the ECM to check mode. Make sure the MIL flashes as shown in the illustration.

2006 TRANSMISSION A750E Automatic Transaxle - Sequoia

Plansa Pictat

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook

Post a comment