Check Steering Angle Sensor

a. Check steering angle sensor installation condition.

2006 BRAKES Brake Control - Sequoia

OK: Steering angle sensor installed correctly. NG: REPAIR OR REPLACE STEERING ANGLE SENSOR OK: GO TO NEXT STEP.

3. CHECK HARNESS AND CONNECTOR (STEERING ANGLE SENSOR - TRANSLATE ECU)

a. Check for open and short circuit in harness and connector between steering angle sensor and translate ECU (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: GO TO NEXT STEP.

4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - TRANSLATE ECU)

a. Check for open and short circuit in harness and connector between skid control ECU and translate ECU (CAN1 circuit).

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: GO TO NEXT STEP.

5. RECONFIRM DTC

RESULT:

RESULT PROCEED

DTC is output

A

DTC is not output

6. REPLACE SKID CONTROL ECU

a. Clear the DTC.

b. Turn the ignition switch OFF.

c. Check if the same DTC still remains in the memory.

RESULT: DTC CHART

2006 BRAKES Brake Control - Sequoia

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • Fausto
    How do i change a steering ange sensor on a 2006 toyota sienna?
    1 year ago
  • silke schultz
    How to do a Steering Angle Sensor Reset on 2007 toyota sequoia limited?
    9 months ago

Post a comment