Check Wire Harness Center Airbag Sensor Assembly Combination Meter

a. Disconnect the connector from the combination meter.

b. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

c. Turn the ignition switch to the ON position.

d. Measure the voltage and resistance according to the value( s) in the table below. OK

TESTER CONNECTION SPECIFIED CONI

>ITION CHART

Tester Connection

Condition

Specified Condition

A20-14 (LA) - C5-29

Always

Below 1 ohms

A20-14 (LA) - Body ground

Always

1 Mohms or higher

|a20-14 (LA) - Body ground|lgnition switch ONI Below 1 ohms | NG: REPAIR OR REPLACE COWL WIRE

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment