Dtc C Stuck In Deceleration Sensor Dtc C Open Or Short In Deceleration Sensor Circuit

description

The skid control ECU receives signals from the yaw rate sensor (deceleration sensor) via the CAN2 communication system.

The yaw rate sensor has a built-in deceleration sensor.

This sensor detects deceleration on the vehicle. The sensor signal is used in ABS and BA and TRAC and VSC control.

DTC CHART

DTC No.

DTC Detecting Condition

Trouble Area

C1232/32

When the lateral deceleration output becomes 4.8 V or more or 0.2 V or less per 0.5 second.

• Yaw rate (Deceleration) sensor

• Yaw rate (Deceleration) sensor circuit

C1244/44

When any of the following conditions are detected:

1. When the supplied voltage to the yaw rate and deceleration sensor becomes 18 V or more or 6.5 V or

• Yaw rate (Deceleration) sensor

2006 BRAKES Brake Control - Sequoia

less.

• Yaw rate (Deceleration)

2. When the longitudinal deceleration output becomes 4.8

sensor circuit

V or more or 0.2 V or less per 0.5 second.

wiring diagram wiring diagram

Abs Deceleration Sensor Rav4
Fig. 50: Stuck Deceleration Sensor Wiring Diagram Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment