Dtc Detection Condition


DTC Detection Condition

Trouble Area


All conditions below are detected for 5 seconds or more.

(1 trip detection logic)

a. Gear change is not performed.

b. Gear position: 4th or 5th c. Transmission input shaft rpm: 300 rpm or less d. Transmission output shaft rpm: 1,000 rpm or more e. Park/neutral position switch: NSW, R and L input signals are OFF

f. Shift solenoid valves and Park/neutral position switch are operating normally.

• Open or short in speed sensor NT circuit

• Automatic transmission (clutch, brake or gear, etc.)

Reference (Using an oscilloscope):

Reference (Using an oscilloscope):

2006 TRANSMISSION A750E Automatic Transaxle - Sequoia

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook

Post a comment