Fig Installing Clutch Drum And Input Shaft Assembly Courtesy of Toyota Motor Sales Usa Inc

c. Install the input shaft sub-assembly with the direct and reverse multiple disc assembly onto the transmission case.

2006 TRANSMISSION A750E Automatic Transaxle - Sequoia

Fig. 326: Installing Input Shaft Sub-Assembly Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

32. INSTALL OIL PUMP ASSEMBLY

a. Install the No. 1 thrust bearing race to the front oil pump

Thrust bearing race diameter THRUST BEARING RACE DIAMETER

Item

Inside

Outside

Race

74.2 mm (2.921 in.)

87.74 mm (3.454 in.)

2006 TRANSMISSION A750E Automatic Transaxle - Sequoia

Fig. 327: Installing No. 1 Thrust Bearing Race To Front Oil Pump Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Coat a new O-ring with ATF, and install it around the oil pump assembly.

c. Place the oil pump through the input shaft, and align the bolt holes of the oil pump assembly with the transmission case.

d. Hold the input shaft, and lightly press the oil pump body to slide the oil seal rings into the overdrive direct clutch drum.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment