Fig. 78: Disconnecting Yaw Rate (Deceleration) Sensor Connector Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4. CHECK HARNESS AND CONNECTOR
a. Check for open and short in harness and connector between master cylinder pressure sensor No.1, No.2, yaw rate sensor control ECU.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: REPLACE SKID CONTROL ECU
DTC is output when zero point calibration is not done for the VSC sensors (yaw rate and master cylinder pressure sensors).
2006 BRAKES Brake Control - Sequoia
DTC is cleared when zero point calibration is done.
Was this article helpful?