Ng Repair Or Replace Harness Or Connector

2006 TRANSMISSION A750E Automatic Transaxle - Sequoia

Fig. 103: Identifying O3 O/D Main Switch Connector Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

OK: GO TO NEXT STEP.

2. INSPECT O/D MAIN SWITCH

a. Measure the resistance.

Standard resistance

TESTER CONNECTION AND SPECIFIED CONE

ITION

Switch Condition

Tester Connection

Specified Condition

O/D main switch pressed and held

1 - 3

Below 1 ohms

2006 TRANSMISSION A750E Automatic Transaxle - Sequoia

O/D main switch released

10 kohms or higher

NG: REPLACE O/D MAIN SWITCH

Fig. 104: Identifying O3 O/D Main Switch Connector Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

OK: GO TO NEXT STEP.

3. CHECK WIRE HARNESS AND CONNECTOR (O/D MAIN SWITCH - ECM)

a. Connect the O3 O/D main switch connector.

b. Disconnect the E4 connector from the ECM.

2006 TRANSMISSION A750E Automatic Transaxle - Sequoia c. Measure the resistance. Standard resistance

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment