Ng Replace Integration Control And Panel Assembly Shift Position L Switch

2006 TRANSMISSION A750F Automatic Transaxle - Sequoia

C121768E01

2006 TRANSMISSION A750F Automatic Transaxle - Sequoia

3. CHECK WIRE HARNESS AND CONNECTOR (SHIFT POSITION L SWITCH - ECM)

a. Install the integration control and panel assembly (shift position L switch).

b. Disconnect the E5 connector from the ECM.

c. Measure the resistance.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION AND RESISTANCE REFERENCE

Switch Condition

Tester Connection

Specified Condition

Shift position L switch pressed and held

E5 - 9 (LMS) - Body ground

Below 1 ohms

Shift position L switch released

E5 - 9 (LMS) - Body ground

10 kohms or higher

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment