NOTE Do not adjust the pedal height Doing so by changing the push rod length of the brake booster will structurally change the pedal ratio

If the pedal height is incorrect, check that there is no damage in brake pedal, brake pedal lever, brake pedal bracket and dash panel.

• Even if there is damage, there is no problem if the reserve distance is within the standard value.

• If necessary, replace them.

2006 BRAKES Brake - Sequoia

Fig. 6: Checking Brake Pedal Height

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Fig. 6: Checking Brake Pedal Height

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2. ADJUST IF NECESSARY, STOP LIGHT SWITCH ASSEMBLY

a. Remove the front door scuff plate, cowl side trim, side panel, lower finish panel and No. 2 heater to register duct (See REMOVAL ).

2006 BRAKES Brake - Sequoia b. Loosen the stop light switch lock nut.

c. Push the brake pedal in 5 - 15 mm (0.20 - 0.59 in.), turn the stop light switch to lock the nut in the position where the stop light goes off.

d. Push the brake pedal in 5 - 15 mm (0.20 - 0.59 in.), check that the stop light lights up.

e. Install the No. 2 heater to register duct, lower finish panel, side panel, cowl side trim and front door scuff plate (See REMOVAL ).

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment