Painted surface

2. DISCONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR

3. DISCONNECT MASTER CYLINDER PRESSURE SENSOR CONNECTOR

4. DISCONNECT WIRE HARNESS

a. Using a clip remover, disconnect the wire harness from the wire harness bracket.

5. DISCONNECT BRAKE LINE

a. Using SST, disconnect the 2 brake lines from the master cylinder.

SST 09023-38201

Fig. 10: Disconnecting Brake Lines From Master Cylinder Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

6. REMOVE BRAKE MASTER CYLINDER

a. Remove the 2 nuts and wire harness bracket.

b. Pull out the master cylinder from the brake booster.

2006 BRAKES Brake - Sequoia

Fig. 11: Removing Brake Master Cylinder Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

DISASSEMBLY

1. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a. Remove the set screw and pull out the reservoir.

b. Remove the cap and strainer from the reservoir.

2. REMOVE MASTER CYLINDER RESERVOIR GROMMET

3. REMOVE BRAKE MASTER CYLINDER GASKET

4. REMOVE MASTER CYLINDER PRESSURE SENSORS

Torque: 25 N*m (250 kgf*cm, 18 ft.*lbf) REASSEMBLY

Reassembly is in the reverse order of disassembly (See DISASSEMBLY ).

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment