The Reset Memory can be performed only with the intelligent tester

Total OBD & ECU Auto Diagnostics

TOAD Auto Software

Get Instant Access

HINT:

The ECM memorizes the vehicle conditions when the ECT controls the automatic transmission assembly and engine assembly. Therefore, when the automatic transmission assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.

The reset procedures are as follows.

a. Turn the ignition switch OFF.

b. Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.

c. Turn the ignition switch ON and push the tester main switch ON.

d. Enter the following menus: DIAGNOSIS / ENHANCED OBD II.

e. Perform the reset memory procedure from the ENGINE menu.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment