Ts And Cg Terminal Circuit

Total OBD & ECU Auto Diagnostics

TOAD Auto Software

Get Instant Access

description

In sensor check mode (test mode), a malfunction of the speed sensor that cannot be judged when the vehicle is stopped is judged while driving.

Transition to sensor check mode (test mode) can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from OFF to ON.

wiring diagram

2006 BRAKES Brake Control - Sequoia

Translate ECU Sub J/B No. 4 ABS and vsc Actuator (Skld Corltro1 ECU>

Translate ECU Sub J/B No. 4 ABS and vsc Actuator (Skld Corltro1 ECU>

Symbole Ftung Dampfbefeuchtung
Fig. 97: TS & CG Terminal Circuit Wiring Diagram Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

inspection procedure

1. CHECK TERMINAL VOLTAGE (DLC3)

a. Turn the ignition switch to the ON position.

b. Measure the voltage between terminals TS and CG of the DLC3.

2006 BRAKES Brake Control - Sequoia

Obd Port 2003 Sequoia
Fig. 98: Checking Terminal Voltage (DLC3) Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

NG: GO TO NEXT STEP.

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3, DLC3 - BODY GROUND)

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR OK: REPLACE SKID CONTROL ECU

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

Post a comment