Go to step C Go to step D Go to step

2007 RESTRAINTS Supplemental Restraint System - Sequoia

2. CHECK CONNECTOR

a. Check that the floor wire connector (on the front seat outer belt RH side) is not damaged.

OK: The lock button is not disengaged, or the claw of the lock is not deformed or damaged. NG: REPAIR OR REPLACE FLOOR WIRE OK: GO TO NEXT STEP.

3. CHECK FLOOR WIRE (FOR SHORT)

a. Release the activation prevention mechanism built into connector "B" (See CHECK MODE PROCEDURE ).

b. Measure the resistance according to the value(s) in the table below. OK

TESTER CONNECTION SPECIFI

ED CONDITION CHART

Tester Connection

Condition

Specified Condition

P11-1 (PR+) - P11-2 (PR-)

Always

1 Mohms or higher

OK: Go to step 10

2007 RESTRAINTS Supplemental Restraint System - Sequoia

Fig. 294: Checking Floor Wire (For Short) Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2007 RESTRAINTS Supplemental Restraint System - Sequoia

4. CHECK FLOOR WIRE (FOR OPEN)

a. Measure the resistance according to the value(s) in the table below.

TESTER CONNECTION SPECIFI

ED CONDITION CHART

Tester Connection

Condition

Specified Condition

P11-1 (PR+) - P11-2 (PR-)

Always

Below 1 ohms

OK: Go to step 11

2007 RESTRAINTS Supplemental Restraint System - Sequoia

Fig. 295: Checking Floor Wire (For Open) Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2007 RESTRAINTS Supplemental Restraint System - Sequoia

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment