Caution Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment

1. Turn the ignition switch to the LOCK position.

2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

3. Disconnect the connectors from the center airbag sensor assembly.

4. Disconnect the connectors from the steering wheel pad.

5. Disconnect the connectors from the front passenger airbag assembly.

6. with Side and curtain shield airbag:

Disconnect the connectors from the side airbag assembly LH and RH.

7. with Side and curtain shield airbag:

Disconnect the connectors from the curtain shield airbag assembly LH and RH.

8. Disconnect the connectors from the front seat outer belt LH and RH. 1. CHECK DTC

a Connect the connectors to the center airbag sensor assembly

2007 RESTRAINTS Supplemental Restraint System - Sequoia b. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

c. Turn the ignition switch to the ON position, and wait for at least 60 seconds.

d. Clear the DTCs stored in memory (See DTC CHECK / CLEAR ).

e. Turn the ignition switch to the LOCK position.

f. Turn the ignition switch to the ON position, and wait for at least 60 seconds.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment