Caution Be sure to perform the following procedures before troubleshooting to avoid unexpected airbag deployment

1. Turn the ignition switch to the LOCK position.

2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

3. Disconnect the connectors from the center airbag sensor assembly.

4. Disconnect the connectors from the steering wheel pad.

5. Disconnect the connectors from the front passenger airbag assembly.

6. with Side and curtain shield airbag:

Disconnect the connectors from the side airbag assembly LH and RH.

7. with Side and curtain shield airbag:

Disconnect the connectors from the curtain shield airbag assembly LH and RH.

2007 RESTRAINTS Supplemental Restraint System - Sequoia

8. Disconnect the connectors from the front seat outer belt LH and RH.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment