Check Battery Voltage

EZ Battery Reconditioning Method

How to Recondition a Battery

Get Instant Access

a. In the case that 20 minutes have not passe4d after stopping the engine, turn on the ignition switch and the electrical system (headlight, blower motor, rear defogger, etc.) for 60 seconds before removing the surface charge.

b. Turn the ignition switch OFF and turn off the electrical systems.

c. Measure the battery voltage between the negative (-) and positive (+) terminals of the battery. Standard voltage: 12.5 to 12.9 V at 20°C (68°F)

If the voltage is less than the specification, charge the battery. HINT:

Check the indicator as shown in the illustration.

2007 ELECTRICAL Charging - Sequoia

Check Battery Terminals
Fig. 3: Measuring Battery Voltage Between Negative (-) & Positive (+) Terminals Of Battery Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2007 ELECTRICAL Charging - Sequoia

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment