Check Curtain Shield Airbag Assembly Lh Curtain Shield Airbag Lh Squib

a. Turn the ignition switch to the LOCK position.

b. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

Disconnect the service wire from connector "C".

d. Connect the connector to the curtain shield airbag assembly LH.

e. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

f. Turn the ignition switch to the ON position, and wait for at least 60 seconds.

g. Clear the DTCs stored in memory (See DTC CHECK / CLEAR ).

h. Turn the ignition switch to the LOCK position.

i. Turn the ignition switch to the ON position, and wait for at least 60 seconds. j. Check the DTCs (See DTC CHECK / CLEAR).

2007 RESTRAINTS Supplemental Restraint System - Sequoia

Fig. 292: Checking Curtain Shield Airbag Assembly LH (Curtain Shield Airbag LH Squib) Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

OK: DTC B1835, B1836, B1837 or B1838 is not output.

HINT:

Codes other than DTC B1835, B1836, B1837 and B1838 may be output at this time, but they are not related to this check.

NG: REPLACE CURTAIN SHIELD AIRBAG ASSEMBLY LH

OK: USE SIMULATION METHOD TO CHECK

DTC B1900/73 SHORT IN FRONT PRETENSIONER SQUIB RH CIRCUIT; DTC B1901/73 OPEN IN

2007 RESTRAINTS Supplemental Restraint System - Sequoia

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment