Check Wire Harness Center Airbag Sensor Assembly Combination Meter

a. Disconnect the connector from the combination meter.

b. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

c. Turn the ignition switch to the ON position.

d. Measure the voltage and resistance according to the value( s) in the table below. OK

TESTER CONNECTION SPECIFIED CONI

>ITION CHART

Tester Connection

Condition

Specified Condition

A20-14 (LA) - C5-29

Always

Below 1 ohms

A20-14 (LA) - Body ground

Always

1 Mohms or higher

|A20-14 (LA) - Body ground|Ignition switch ON] Below 1 ohms | NG: REPAIR OR REPLACE COWL WIRE

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment