Front Speed Sensor

COMPONENTS

2007 BRAKES Brake Control - Sequoia

C1H9MEH'

Fig. 104: Identifying Front Speed Sensor Components With Torque Specification REMOVAL

1. REMOVE FRONT WHEEL

2. DISCONNECT SPEED SENSOR CONNECTOR

3. REMOVE FRONT SPEED SENSOR LH

a. Remove the clips and 3 clamp bolts holding the sensor harness from the frame, upper arm and steering knuckle.

b. Remove the bolt and speed sensor from the steering knuckle. Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

INSTALLATION

Installation is in the reverse order of removal (See FRONT SPEED SENSOR ). HINT:

After installation, check speed sensor signal (See TEST MODE PROCEDURE ).

2007 BRAKES Brake Control - Sequoia

Fig. 105: Locating Front Speed Sensor Bolt

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment