Grease capacity Color Black g oz

2007 DRIVELINE/AXLES Drive Shaft - Sequoia

2003 Rav4 Drive Shaft Disassembly
Fig. 14: Aligning Matchmarks While Putting In Inboard Joint Shaft Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

6. INSTALL BOOT TO FRONT DRIVE INBOARD JOINT

a. Pack the inboard joint and boot with grease in the boot kit.

Grease capacity (Color = Black): 190 - 210 g (6.70 - 7.41 oz.)

b. Temporarily install the boot to the inboard joint shaft.

7. CHECK FRONT DRIVE SHAFT LENGTH

a. Make sure that the 2 boots are on the shaft groove.

b. Make sure that the 2 boots are not stretched or contracted when the drive shaft is at standard length. Drive shaft standard length:

8. INSTALL LARGE INBOARD JOINT BOOT CLAMP TO INBOARD JOINT BOOT

a. Place the large inboard joint boot clamp.

2007 DRIVELINE/AXLES Drive Shaft - Sequoia

N C124198

Fig. 15: Checking Front Drive Shaft Length Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Using pliers, compress the clamp and attach the claws.

Cutting Boot Clamp Schematic
Fig. 16: Compressing Clamp & Attaching Claws

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

9. INSTALL OTHER BOOT CLAMP TO BOTH BOOTS SST 09521-24010

a. Secure the clamp onto the boot.

b. Place SST onto the clamp.

SST 09521-24010

c. Tighten the SST so that the clamp is pinched.

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment