Inspect Speed Sensor

1. Make sure that there is no looseness at the connector lock part and connecting part of the connector.

2. Disconnect the speed sensor connector.

2007 BRAKES Brake Control - Sequoia

3. Measure the resistance between terminals 1 and 2 of the speed sensor connector. OK:

Resistance: 0.92 to 1.22 kohms

Fig. 37: Measuring Resistance Between Terminals 1 And 2 Of Speed Sensor Connector

4. Measure the resistance between terminals 1 and 2 of the speed sensor connector and body ground.

Resistance: 1 Mohms or higher b. Rear:

1. Make sure that there is no looseness at the connector lock part and connecting part of the connector.

2. Disconnect the speed sensor connector.

3. Measure the resistance between terminals 1 and 2 of the speed sensor connector. OK:

Resistance: 1.8 to 2.2 kohms

4. Measure the resistance between terminals 1 and 2 of the speed sensor connector and body ground.

Fig. 38: Measuring Resistance Between Terminals 1 And 2 Of Speed Sensor Connector

2007 BRAKES Brake Control - Sequoia

Resistance: 1 Mohms or higher NG: REPLACE SPEED SENSOR OK: GO TO Next Step

3. CHECK HARNESS AND CONNECTOR (SPEED SENSOR - SKID CONTROL) NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: GO TO Next Step

4. CHECK SPEED SENSOR

a. Check the speed sensor installation.

OK: The installation bolt is tightened properly and there is no clearance between the sensor and the front steering knuckle or the rear axle carrier.

NG: REPLACE SPEED SENSOR

Fig. 39: Checking Speed Sensor Installation OK: GO TO Next Step

5. CHECK SPEED SENSOR AND SENSOR ROTOR SERRATIONS

a. Inspection using oscilloscope

1. Connect the oscilloscope to the terminal FR+ - FR-, FL+ - FL-, RR+ - RR- and RL+ - RL- of the skid control ECU.

2. Drive the vehicle at about 12 mph (20 km/h), and check the signal waveform. OK: A waveform as shown in the figure should be output.

2007 BRAKES Brake Control - Sequoia

Normal Signal Waveform

^ GNU 1 V1 Division 2 m/s I Division

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment