Ng Replace Parking Brake Switch Assembly

Fig. 86: Inspecting Parking Brake Switch Assembly OK: GO TO Next Step

2007 BRAKES Brake Control - Sequoia

3. CHECK HARNESS AND CONNECTOR (TRANSLATE ECU - PARKING BRAKE SWITCH) NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: GO TO Next Step

4. CHECK BRAKE FLUID LEVEL WARNING SWITCH

a. Disconnect the brake fluid level warning switch connector.

b. Measure the resistance according to the value(s) in the table below.

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection

Switch Condition

Specified Condition

(B2-1) - (B2-2)

Float UP

10 kohms or more (No continuity)

(B2-1) - (B2-2)

Float DOWN

1 ohms or less (Continuity)

Fig. 87: Checking Brake Fluid Level Warning Switch NG: REPLACE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY OK: GO TO Next Step

5. CHECK HARNESS AND CONNECTOR (BRAKE FLUID LEVEL WARNING SWITCH -TRANSLATE ECU)

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR OK: GO TO Next Step

6. CHECK HARNESS AND CONNECTOR (TRANSLATE ECU - SKID CONTROL ECU) NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: GO TO Next Step

2007 BRAKES Brake Control - Sequoia

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment