Perform Zero Point Calibration

Total OBD & ECU Auto Diagnostics

TOAD ECU Tuning Software

Get Instant Access

a. Connect the intelligent tester to the DLC3.

b. Turn the ignition switch to the ON position.

c. Using the intelligent tester, perform "Zero point calibration" (See INITIALIZATION ). OK: The "COMPLETED" is displayed on the tester screen.

OK: GO TO NEXT STEP.

4. PERFORM SENSITIVITY CHECK

a. Using the intelligent tester, perform "Sensitivity check" (See INITIALIZATION ).

OK: Standard value: 27 to 33 kg (59.52 to 72.75 lb) NG: Go to step 5 OK: END

5. RETIGHTEN FRONT SEAT ASSEMBLY RH BOLT

a. Turn the ignition switch to the LOCK position.

b. Loosen the 4 installation bolts of the front seat assembly RH.

c. Tighten the 4 installation bolts of the front seat assembly RH to the specified torque.

Torque: 37 N*m (380 kgf*cm, 27 ft.*lbf) NG: Go to step 8 OK: GO TO NEXT STEP.

6. PERFORM ZERO POINT CALIBRATION

a. Connect the intelligent tester to the DLC3.

b. Turn the ignition switch to the ON position.

c. Using the intelligent tester, perform "Zero point calibration" (See INITIALIZATION ). OK: The "COMPLETED" is displayed on the tester screen.

OK: GO TO NEXT STEP.

7. PERFORM SENSITIVITY CHECK

a. Using the intelligent tester, perform "Sensitivity check" (See INITIALIZATION ).

Standard value: 27 to 33 kg (59.52 to 72.75 lb) NG: Go to step 8 OK: END

2007 RESTRAINTS Supplemental Restraint System - Sequoia

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment