Rear Speed Sensor

COMPONENTS

Fig. 106: Identifying Rear Speed Sensor Components With Torque Specification REMOVAL

1. DISCONNECT REAR SPEED SENSOR CONNECTOR

2. REMOVE REAR SPEED SENSOR LH

a. Remove the 6 resin clips holding the sensor wire harness.

b. Remove the bolt and speed sensor from the axle carrier.

Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) INSTALLATION

Installation is in the reverse order of removal (See REAR SPEED SENSOR ). HINT:

After installation, check speed sensor signal (See TEST MODE PROCEDURE ).

Fig. 107: Identifying Rear Speed Sensor Connector Bolt

2007 BRAKES Brake - Sequoia

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment