Remove Water Inlet And Inlet Housing Assembly

a. Disconnect the water bypass hose from the water inlet housing.

b. Remove the 2 bolts holding the water inlet housing to the water pump.

c. Disconnect the water inlet housing from the front water bypass joint, and remove the water inlet and inlet housing assembly.

d. Remove the O-ring from the water inlet housing.

Fig. 5: Removing Bolts Holding Water Inlet Housing To Water Pump Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

5. REMOVE WATER PUMP

a. Remove the 5 bolts, 2 stud bolts, nut, water pump and gasket.

2007 ENGINE Cooling - Sequoia b. Remove the O-ring from the water bypass pipe.

Sequoia Water Pump Bolts
Fig. 6: Removing Bolts & Stud Bolts, Nut, Water Pump & Gasket Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Responses

  • Salvia Hayward
    Where is the location d squib circuit on toyota hilux?
    8 years ago
  • Nicol
    How to repair TOYOTA RAV4 WATER PUMP 96?
    8 years ago
  • johanna barth
    Where is the location of the water pump on a 2007 6 cyl camry?
    8 years ago
  • Miia Kallio
    How to remove the water inlet housing from a 2007 3.5 camry?
    4 years ago
  • marie
    How to remove the water inlet housing 2010 sienna?
    4 years ago

Post a comment