Seal packing Part No or equivalent

• Parts must be assembled within 3 minutes of application. Otherwise the material must be removed and reapplied.

• Immediately remove nozzle from the tube and reinstall cap.

2007 ENGINE Cooling - Sequoia

Seal Width 2-3 mm

2001 Sequoia Coolant Gasket

K A122971E01

Fig. 12: Applying Seal Packing To Sealing Groove Of Water Inlet Housing Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

c. Install a new O-ring to the water inlet housing.

d. Apply soapy water on the O-ring.

e. Attach the water inlet housing end to the front water bypass joint hole.

f. Install the water inlet and housing assembly with the 2 bolts. Alternately tighten the bolts.

HINT:

Each bolt length is indicated in the illustration. Bolt length: 76 mm (3.00 in.) for A 22 mm (0.87 in.) for B

g. Connect the water bypass hose to the water inlet housing.

2007 ENGINE Cooling - Sequoia

Timing Belt Toyota Sequoia
Fig. 13: Installing Water Inlet & Housing Assembly With Bolts Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

3. INSTALL NO.2 IDLER PULLEY INSTALLATION

4. INSTALL TIMING BELT (See INSTALLATION )

5. FILL WITH ENGINE COOLANT

6. START ENGINE AND CHECK FOR ENGINE COOLANT LEAKS

7. RECHECK ENGINE COOLANT LEVEL

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment