Sst

Total OBD & ECU Auto Diagnostics

TOAD OBD Scanner

Get Instant Access

3. Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output, and check if the SRS warning light comes on after 3 seconds of disconnecting.

4. Within 2 to 4 seconds after the SRS warning light comes on, connect terminals TC and CG of the DLC3.

5. The SRS warning light should go off within 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Then, disconnect terminal TC within 2 to 4 seconds after the SRS warning light goes off.

6. The SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal TC. Then, reconnect terminals TC and CG within 2 to 4 seconds after the SRS warning light comes on.

7. Check if the SRS warning light goes off 2 to 4 seconds after connecting terminals TC and CG of the DLC3. Also check if the normal system code is output within 1 second after the SRS warning light goes off.

If DTCs are not cleared, repeat this procedure until the codes are cleared.

2007 RESTRAINTS Supplemental Restraint System - Sequoia

Fig. 52: Identifying Blinking Pattern

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Fig. 52: Identifying Blinking Pattern

Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment