Standard exposed length mm in Minimum exposed length mm in

If the exposed length is less than the minimum, replace the brushes and the brush holder assembly.

2007 ELECTRICAL Charging - Sequoia

Fig. 20: Measuring Exposed Brush Length Using Vernier Caliper Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

3. INSPECT BEARING

a. Check the bearing is not rough or worn.

If necessary, replace the bearing (See INSPECTION ). REPLACEMENT

1. REPLACE FRONT BEARING

a. Remove the 4 screws, the bearing retainer and the bearing.

2007 ELECTRICAL Charging - Sequoia

Fig. 21: Removing Screws, Bearing Retainer & Bearing Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

b. Using SST and a hammer, tap out the bearing.

SST 09950-60010 (09951-00250), 09950-70010 (09951-07100)

2007 ELECTRICAL Charging - Sequoia

Fig. 22: Tapping Out Bearing Using SST & Hammer Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

c. Using SST and a press, press in a new bearing.

SST 09950-60010 (09951-00470), 09950-70010 (09951-07100)

d. Install the bearing retainer with the 4 screws. Torque: 2.6 N*m (27 kgf*cm, 23 in.*lbf)

2007 ELECTRICAL Charging - Sequoia

Fig. 23: Pressing New Bearing Using SST & a Press Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

2. REPLACE REAR BEARING

a. Using SST, remove the bearing cover (outside) and the bearing.

SST 09820-00021

NOTE:

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment