Temporarily Install Outboard And Inboard Joint Boots And Boot Clamps


• Before installing the boots, wrap the spline of the outboard joint shaft with vinyl tape to prevent the boots from bearing damaged.

• Before installing the boots, place 3 new clamps to the small boot ends and large boot end (outboard joint side).

2007 DRIVELINE/AXLES Drive Shaft - Sequoia

Fig. 13: Wrapping Spline Of Outboard Joint Shaft With Vinyl Tape Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Was this article helpful?

0 0
Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook

Post a comment