• The cylinder head bolts are tightened in 2 progressive steps (steps (c) and (e)).
• If any bolt is broken or deformed, replace it.
(a) Apply a light coat of engine oil on the threads and under the heads of the cylinder head bolts.
(b) Install the plate washer to the cylinder head bolt.
(c) Install and uniformly tighten the cylinder head bolts on each cylinder head, in several passes, in the sequence shown, then repeat for the other side, as shown. Torque: 54 Nm (550 kgfcm, 40 ftlbf)
If any of the cylinder head bolts does not meet the torque specification, replace the cylinder head bolt.
(d) Mark the front of the cylinder head bolt head with paint.
(e) Retighten the cylinder head bolts by 90° in the numerical order shown.
(f) Check that the painted mark is now at a 90° angle to the front.
Was this article helpful?