Removal

NOTICE:

• If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC position, DTCs will be recorded.

• Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.

• Never reuse the sensor involved in a collision when the SRS has deployed.

• Never repair a sensor in order to reuse it.

REMOVE FRONT AIRBAG SENSOR

(a) Disconnect the front airbag sensor connector.

(b) Remove the 2 bolts and front airbag sensor.

REMOVE FRONT AIRBAG SENSOR

(a) Remove the 2 fender liner set screws.

(b) Disconnect the wire harness from the front airbag sensor

(c) Disconnect the front airbag sensor connector.

(d) Remove the 2 bolts and front airbag sensor.

Was this article helpful?

0 0
Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment