Center Rail Garnish Removal

1. REMOVE SLIDE DOOR

(a) Remove the 2 bolts and open striker. Torque: 7.0 Nm (71 kgfcm, 62 in.lbf)

(b) Remove the rear door check cover.

(c) Remove the screw, then using a screwdriver, remove the center rail garnish.

HINT:

Tape the screwdriver tip before use.

Toyota Sienna 2010 Bolt Fastening Torque

Remove the bolt and center rail protector Torque: 9.8 Nm (100 kgfcm, 7 ftlbf)

(e) Remove the upper rail cushion.

Remove the 2 bolts from the slide door.

(g) Slide the slide door rearward, remove each hinge from the rails and slide door.

2. REMOVE BACK DOOR SCUFF PLATE (See page BO-75 or BO-79 )

3. REMOVE SLIDE DOOR SCUFF PLATE (See page BO-75 or BO-79 )

4. REMOVE SPEAKER GRILLE (See page BO-75 or BO-79 )

5. REMOVE QUARTER TRIM COVER (See page BO-75 or BO-79 )

6. REMOVE QUARTER TRIM PANEL (See page BO-75 or BO-79 )

Do It Yourself Car Diagnosis

Do It Yourself Car Diagnosis

Don't pay hundreds of dollars to find out what is wrong with your car. This book is dedicated to helping the do it yourself home and independent technician understand and use OBD-II technology to diagnose and repair their own vehicles.

Get My Free Ebook


Post a comment