Replacement

1. REMOVE BACK DOOR STAY

(a) Remove the bolt and back door stay from the back door. HINT:

While supporting the back door with your hand, remove the back door stay.

(b) Remove the bolts and back door stay from the body.

2. IF NECESSARY, REPLACE BACK DOOR STAY NOTICE:

When handling the back door stay. • Do not disassemble the back door stay because the cylinder is filled with pressurized gas.

• If the back door stay is to be replaced, drill a 2.0 - 3.0 mm (0.079 - 0.118 in.) hole in the bottom of the back door stay as shown in the illustration to completely release the high-pressure gas before disposing of it.

• When drilling, chips may fly out so work carefully.

• The gas is colorless, odorless and non-toxic.

• When working, handle the back door stay carefully. Never score or scratch the exposed part of the piston rod, and never allow paint or oil to get on it.

• Do not turn the piston rod and cylinder with the back door stay fully extended.

3. INSTALL BACK DOOR STAY

(a) Install the bolts and back door stay to the body. Torque: 22 Nm (225 kgfcm, 16 ftlbf)

(b) Install the bolt and back door stay to the back door. Torque: 17 Nm (175 kgfcm, 13 ftlbf)

BODY ELECTRICAL - WIRELESS DOOR LOCK CONTROL SYSTEM_

BE0IO-06

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment