Torque Nm kgfcm ftlbf

14. INSTALL RH ENGINE MOUNTING STAY

Install the RH mounting stay with the 3 bolts. Torque: 32 Nm (320 kgfcm, 23 ftlbf) REMOVE ENGINE SLING DEVICE CONNECT FENDER APRON SEALS INSTALL ENGINE UNDER COVER

18. CONNECT PS HOSE TO PS RESERVOIR PIPE

CONNECT PS HOSE TO PS OIL RESERVOIR CONNECT INTERMEDIATE SHAFT ASSEMBLY (See page SR-20)

INSTALL DRIVE SHAFTS (See page SA-23 ) CONNECT STABILIZER BAR LINK (See page SA-42)

INSTALL ENGINE FENDER APRON SEALS

INSTALL FRONT EXHAUST PIPE

Temporarily install 3 new gaskets and the front exhaust pipe with the 2 bolts, 2 compression springs and 4 nuts. Tighten the 4 nuts holding the exhaust manifolds to the front exhaust pipe.

Torque: 62 Nm (630 kgfcm, 46 ftlbf)

Tighten the 2 bolts and 2 compression springs holding the front exhaust pipe to the center exhaust pipe. Torque: 43 Nm (440 kgfcm, 32 ftlbf) Install the support stay with the 2 bolts. Torque: 33 Nm (330 kgfcm, 24 ftlbf)

Simple Car Care Tips and Advice

Simple Car Care Tips and Advice

Put an End to All Your Car Troubles. Does Your Car Break Down Often? Are You Spending More On Fuel Than You Thought You Would? Is Maintaining Your Car Eating Into Your Budget? Make Your Car Last Longer with Some Simple Do It Yourself Tips.

Get My Free Ebook


Post a comment