(a) Pack in grease to the inboard tulip and boot. HINT: Use the grease supplied in the boot kit. Grease capacity: 270 - 280 g (0.60 - 0.62 lb>
(b) Align the matchmarks placed before disassembly.
(c) Install the boot to the inboard tulip.
7. ASSEMBLE BOOT CLAMPS TO BOTH BOOTS
(a) 8e sure the boot is on the shaft groove.
(b) Bend the band and lock it as shown in the figure.
(c) Insure that the boot is not stretched or contracted when the drive shaft is at standard length.
Was this article helpful?