Disassembly Of Rear Axle

1. REMOVE DUST DEFLECTOR

Using a screwdriver, remove the deflector from the axle caliper.

2. REMOVE INNER OIL SEAL

Using a screwdriver, remove the inner oil seal.

3. REMOVE AXLE SHAFT FROM AXLE CARRIER

(a) Using SST, remove the axle shaft from the axle carrier. SST 09950-20017

(b) Using SST. remove the bearing inner race (outside) from the axle hub.

SST 09950-20017

4. REMOVE OUTER OIL SEAL

Using a screwdriver, remove the oil seal from the axle carrier.

5. REMOVE BEARING

(a) Using snap ring pliers, remove the snap ring.

(b) Using SST, press out the bearing outer race from the axle carrier.

SST 09608 35014 (09608-06020. 09608 06100) NOTICE: Always replace the bearing as an assembly.

(c) Remove the bearing inner race (inside) and two bearings from the bearing outer race.

6. IF NECESSARY, REPLACE LOWER CONTROL ARM BUSHING

(a) Using SST. press out the lower control arm bushing.

SST 09527-20011

09710-14012 (09710-00030. 09710 00050)

(b) Using SST. press in a new lower control arm bushing.

SST 09527 20011

09710-14012 (09710 00030, 09710 00050)

Toyota Supra 2096

7. IF NECESSARY. REPLACE LOWER BALL BUSHING

(a) Using SST. press out the lower ball bushing. SST 09710-30020 (09710 03040. 09710 03070)

(b) Using SST. press in a new lower ball bushing. SST 09710 30020 (09710 03070. 09710-03100)

Toyota Supra Mk3

Was this article helpful?

0 0

Post a comment