1. INSPECT EXTENSION HOUSING BUSHING
Using a cylinder gauge, measure the inside diameter of the extension housing bushing.
Maximum inside diameter: 40.09 mm (1.5783 in.)
If the inside diameter is greater than the maximum, replace the extension housing.
2. IF NECESSARY. REPLACE OIL SEAL
(a) Using SST. remove the oil seal.
09308-10010 with output shaft installed
(b) Using SST. drive in a new oil seal as far as it will go. SST 09325 40010
(c) Coat the oil seal lip with MP grease.
Was this article helpful?