Inspection Of Actuator Operation

1. INSPECT BATTERY VOLTAGE Battery voltage: 10 - 14.5 V

2. DISCONNECT CONNECTORS FROM ACTUATOR

Disconnect the three connectors from the actuator.

w0167

A.B.S. Actuator COMPONENTS

w0167

SST

Actuator

fTn rft"V-

lf:'° 1 |o O o

Ll.LJ Mil

LT

WM

To Body-

-©.©J

T p® ■

Sub-Wire Harness (SST)

3. CONNECT ACTUATOR CHECKER (SST) TO

ACTUATOR

(a) Connect the actuator checker (SST) to the actuator and body side wire harness through the sub-wire harness (SST) as shown.

SST 09990-00150

(b) Connect the red cable of the checker to the battery positive (+) terminal and black to the negative (-) terminal. Connect the black cable of the sub-wire harness to the battery negative (-) terminal or body ground.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment