Install Valve Body

(a) Align the groove of the manual valve to the pin of the lever.

(b) Connect the throttle cable to the cam.

(c) Confirm the springs into the accumulator pistons are installed correctly.

23 32

23 32

(0.91) (0.91)

(d) Install the seventeen bolts.

HINT: Each bolt length (mm, in.) is indicated in the figure. Torque: 100 kg-cm (7 ft-lb, 10 N-m)

34. INSTALL SOLENOID WIRING

(a) Coat a new O-ring with ATF and install it to the grommet.

(b) Insert the solenoid wiring to the case and install the stopper plate.

(c) Connect the connectors to No.1, No.2 and lock up solenoid.

AT13S4

35. INSTALL OIL TUBES

Using a plastic hammer, install the two tubes into positions shown in the figure.

NOTICE: Be careful not to bend or damage the tubes.

AT 6009
Black

AT13S4

Clamp

36. INSTALL OIL STRAINER AND GASKETS

<a) Install two new gaskets to the oil strainer.

(b) Install and torque the three bolts. Torque: 100 kg-cm (7 ft-lb, 10 N-m)

<c> Clamp the solenoid wire.

37. INSTALL MAGNETS IN PAN

Install the four magnets in the indentations of the oil pan as shown in the figure.

38. INSTALL OIL PAN

(a) Remove any packing material and be careful not to drop oil on the contacting surfaces of the transmission case and oil pan.

(b) Apply seal packing to the oil pan as shown in the figure.

Seal packing: Part No. 08826 00090, THREE BOND 1281 or equivalent

(c) Install and torque the nineteen bolts. Torque: 75 kg-cm (65 in.-lb, 7.4 N-m)

Clamp

Was this article helpful?

0 0

Post a comment