1. INSTALL BUMPER, COIL SPRING AND SUSPENSION SUPPORT
4a) Mount the shock absorber in a vise. <bj Using SST, compress the coil spring. SST 09727-30020
(c) Install the bumper to the shock absorber.
(d> Align the coil spring end with the lower seat hollow and install the coil spring.
(e) Align the suspension support hole and piston rod and install it.
(f > Align the suspension support with the shock absorb er lower bushing as shown.
(g) Install the suspension support nut. Torque: 280 kg-cm (20 ft-lb, 27 N-m)
Shock Absorber Bushing
2. CONNECT SHOCK ABSORBER ASSEMBLY TO BODY
Connect the shock absorber assembly with the three nuts. Torque: 145 kg-cm (10 ft-lb, 14 N-m)
3. INSTALL SHOCK ABSORBER ASSEMBLY
(a) Connect the shock absorber assembly to the axle carrier.
(b) Install the TEMS actuator and shock absorber cap.
4. INSTALL QUARTER TRIM AND SPEAKER GRILLE
Was this article helpful?