Remove Components Of First And Reverse Brake Piston

(a) Set SST on the spring retainer, and compress the return spring.

SST 09350-30020 (09350-07050)

(b) Remove the snap ring with snap ring pliers.

(c) Remove the piston return spring.

(d) Hold No. 2 first and reverse brake piston with hand, apply compressed air to transmission case to remove No. 2 first and reverse brake piston.

(e) Remove No. 2 first and reverse brake piston.

If the piston does not pop out with compressed air, lift the piston out with needle-nose pliers.

(f) Remove the O-ring from No. 2 piston.

(g) Insert SST behind the reaction sleeve and gradually lift it out of the transmission case.

SST 09350-30020 (09350 07080)

(h) Remove the O-ring from the reaction sleeve.

(i) Insert SST behind No. 1 brake piston and gradually lift it out of the transmission case.

SST 09350-30020 (09350-07090)

(j) Remove the two O-rings from No. 1 piston.

40. REMOVE MANUAL VALVE LEVER, SHAFT AND OIL SEALS

(a) Using a chisel, cut off the spacer and remove it from the shaft.

(b) Using a pin punch, drive out the pin.

(c) Pull the manual valve lever shaft out through the case and remove the lever.

(d) Using a screwdriver, remove the two oil seals.

0 0

Post a comment